| Author | Comments |
|---|---|
|
Owen Whisnant
Posted: Aug 24, 2011 10:52 PM
|
MH3 stops pumping
Hey all I NEED HELP I have a glas craft MH3. It is about 2 years old. Got it just after the G boys bought glas craft. It has recently developed a problem of stopping its pump stroke just before it reaches the bottom stroke sensor. Has anyone had this problem b4. 1 other thing I installed the A side shaft seal kit could this be part of the problem. I would really appreciate any knowledge you might be able to share.Lee |
|
John Shockney
Posted: Aug 26, 2011 09:16 PM
|
I had a problem with ISO crystals around the shaft seal on my Guardian causing it to stop pumping. Did you clean and polish the pump shaft when you replaced the seal? Airpro |
|
Owen Whisnant
Posted: Aug 29, 2011 10:22 AM
|
Thank you George. I posted this thread and who shows up right away but George Spanos from SFDONE. It seems that he solved the issue in about 5 minutes. Ending the frustration. This is why a quality distributor is so important to success. Thanks again George |
Copyright 2025. All Rights Reserved.
