Q&A Forums
temperature settings Post New Topic | Post Reply
| Author | Comments |
|---|---|
|
ben wright
Posted: Oct 13, 2008 02:38 AM
|
temperature settings
Can I get some insight into setting up hose heat and preheattemperature settings.I'm using 2# RTC cc foam.A new Reactor H-40 machine and a d gun.The manufacture calls for 110-120 A Side,110-130 B side. Do I set at lowest temp and adjust as I go to get the best pattern and performance.Do I change with the speed of chemical output? Thankyou. |
|
clint moore
Posted: Oct 13, 2008 10:42 AM
|
Here is a good starting point, set your temperatures at 120 across the board,pressure at 1200. Now because your B side material is thicker run it about 10 degrees higher. bring your hose heat up to target temp. before turning on preheaters. Hose takes about 30 -45 min. to heat ,preheaters take 15-30 seconds.Test spray to see how your foam looks and make adjustments accordingly.Colder ambient temperatures require more heat,hotter require less.Some will disagree,just my two cents. |
