Q&A Forums

E20 Post New Topic | Post Reply

Author Comments
jacob carlson
Posted: Jul 28, 2011 07:50 PM
The B side on my e20 makes a loud rattling noise when it strokes. The fluid section was rebuilt recently, and I had a new connecting rod installed. The gears look fine, any Ideas?
Posted: Jul 28, 2011 11:06 PM
How does the arm connecting the pump to the shaft on the motor. If I remember correctly, there is either a bushing or bearing that fits onto the motor shaft. If that bearing goes out, it will make a lot of noise.
Posted: Jul 29, 2011 07:52 AM
Is the pump screwed up into the housing to the right height? You should have the top of the threads of the pump just flush or 1 thread above the bearing housing. Is the large star nut tight?

jacob carlson
Posted: Jul 29, 2011 09:41 AM
The fluid section was quite a few threads below the housing, cranked it up, tightened the star nut and it quit rattling. Thanks.

You need to login to reply to this topic. Please click here to login.