Q&A Forums
CAL3200 Gusmer FF 1600 Post New Topic | Post Reply
| Author | Comments |
|---|---|
|
Posted: May 12, 2009 12:50 AM
|
CAL3200 Gusmer FF 1600
Hi I am trying to get my new Hose temp. controller set up. As a new foamer I have limited knowledge...Is there anyone out here who can help me set it up? I have it now so i can see the temperature...but If i set the setpoint 1 to say, 80 degrees F, it just goes above it. The controller on the machine before this had the buttons ripped off. I tried to put the buttons from the new one on the old, but there was too much junk in the slots. Anyways...Like I said, I have limited knowledge, along with my supplier, Graco support, and whoever else I have asked in the past month. -Drew |
|
JR Burnett
Posted: May 12, 2009 09:47 AM
|
Give me a call, I have been working on these older machines for years.. JR (706) 818-1942 |
